Pump Pliers

Sheffield Plumber : How Do I Remove A Radiator?
How do I remove a radiator?
I want to remove a radiator in my living room so I can decorate. How do I disconnect it?
How to remove a radiator
Removing a radiator can be done without draining the whole system.
Radiators have two valves either end of the radiator, one side will be operational this will either be a wheel head or a TRV (Thermostatic Radiator Valve) and the other side will have a lockshield this normally has a cone shaped cap on.
- Firstly start off by isolating the radiator – to do this close both radiator valves. Turning the valves fully clockwise will close the valves, ( note the amount of turns its takes to close off the lockshield ) for the lockshield valve you will need to pull off the cone shaped cap, you will then see a brass stem with two flat edges to allow you to close the valve with spanner.
- Check that the radiator is isolated – to do this use a radiator key and unscrew the bleed valve at the top of the radiator you should get a steady trickle of water which will eventually stop if this is not the case, check you have fully closed off the radiator valves.
Thermostatic radiator valves can sometimes leak even when fully closed, if you are leaving the radiator of for a long period of time it may be better to a cap off the valve.
Make sure you have some rags and a bowl beneath the radiator before you begin. You will also need a large bucket to empty the water from the bowl.
- Open the bleed valve (this will allow water to drain from the radiator)
- Loosen radiator valves - With a pair of water pump pliers or similar grip the valve body to prevent any damage to pipework. With an adjustable spanner loosen the nut which connects the valve to the radiator.
- Drain Radiator – Water will then start to trickle out, let the water run into the bowl (it will help if you have the larger bucket to hand to empty the water from the smaller bowl. Continue this until the water has stopped running.
- Remove the radiator - depending on the size of the radiator, it will help if there are two people to remove it. Close the bleed valve and block both holes with rags, then simply lift the radiator up off the brackets (do not pull the radiator as this will pull the brackets off the wall) then turn upside down as there may be excess water and sludge.
Refit the radiator
- 1. Lift the radiator back onto its brackets
- 2. With the water pump pliers grip the valve body and with the adjustable spanners tighten the union nuts.
- 3. Slowly open the lockshield valve (turning anti-clockwise) turn it the same amount of turns it took to turn it off. At this stage you can start checking both valves for leaks.
- 4. Turn on the thermostatic radiator valve or wheelhead.
- 5. Then open the bleed valve using the radiator key, this will allow any trapped air to escape
- 6. Once water starts to trickle from the bleed valve close it.
Always exercise extreme caution when carrying out any plumbing repairs, as mistakes can be costly. If you are unsure feel free to contact us via our website below:
Sheffield plumber.
About the Author
KNIPEX Cobra Water Pump Pliers Product Video
|
|
Draper Expert Knipex 88148 250 mm Alligator Water Pump Pliers $53.69 |
|
|
C.K 3659A Water Pump Pliers 240mm $53.43 |
|
|
Rolson 21037 300mm Water Pump Pliers $24.23 |
|
|
Knipex-Werk C. Gustav Putsch Cobra ES 8751250 Water Pump Pliers Chrome Vanadium $81.40 |
|
|
Knipex Alligator Water Pump Pliers 300 mm $80.03 |
|
|
Knipex 8801250 Alligator Water Pump Pliers $52.51 |
|
|
Knipex 8701400 Cobra Water Pump Pliers 95 mm Capacity $138.71 |
|
|
Knipex 8701300 Cobra Water Pump Pliers 60 mm Capacity $83.17 |
|
|
Draper Expert Knipex 82898 250 mm Water Pump Pliers $43.57 |
|
|
Draper Expert Knipex 13759 400 mm Cobra Water Pump Pliers $136.77 |
|
|
Draper Expert Knipex 13277 250 mm Cobra Water Pump Pliers $61.31 |
|
|
Knipex 8702250 Cobra Water Pump Pliers 46 mm Capacity $61.71 |
|
|
Draper 19207 Soft Jaw Water Pump Pliers $31.14 |
|
|
Faithfull 121/250 Water pump Plier 10In $30.86 |
|
|
Stanley Water pump Pliers 240MM 0 84 076 $32.57 |
|
|
Knipex 8701250 Cobra Water Pump Pliers 46 mm Capacity $60.43 |
|
|
Knipex 8701180 Cobra Water Pump Pliers 30 mm Capacity $58.14 |
|
|
Knipex 87 01 400 Sb Cobra Water Pump Pliers $151.09 |
|
|
Knipex 8751250 Cobra ES Extra Slim Water Pump Pliers 42 mm Capacity $66.14 |
|
|
Gedore 145 15 C 15-inch Water Pump Pliers with 9 Settings $111.17 |
|
|
Gedore 145 10 JC 10-inch Water Pump Pliers with 7 Settings $51.29 |
|
|
Draper Expert Knipex 75357 250 mm Cobra Water Pump Pliers $60.09 |
|
|
Draper Expert 40212 250 mm Long-Jaw Cobra Water Pump Pliers $64.51 |
|
|
Rolson Tools 21035 250mm Water Pump Plier $16.31 |
|
|
Draper Knipex 40123 250 mm Smart-Grip Automatic Water Pump Pliers $95.26 |
|
|
Draper Expert 89901 250 mm Water Pump Pliers $31.51 |
|
|
Draper 34672 250 mm VDE Cobra Chrome Water Pump Pliers $99.14 |
|
|
Draper Expert Knipex 75355 250 mm Alligator Water Pump Pliers $46.03 |
|
|
Draper Expert Knipex 88147 300 mm Cobra Water Pump Pliers $90.09 |
|
|
Draper Expert Knipex 88150 300 mm Alligator Water Pump Pliers $71.17 |
|
|
Blue Spot 12 inch Water Pump Pliers $14.46 |
|
|
Blue Spot 10 inch Water Pump Pliers $10.80 |
|
|
Silverline PL48 400 mm Expert Water Pump Plier $31.80 |
|
|
Faithfull PL121315 121/315 Water Pump Plier 12-inch $53.37 |
|
|
Draper Expert Knipex 59812 180 mm Alligator Water Pump Pliers $49.11 |
|
|
Draper Expert Knipex 30737 300 mm Cobra Water Pump Pliers $81.17 |
|
|
Rolson 18600 Set Pipe Wrench and Water Pump Pliers (2 Pieces) $25.71 |
|
|
Draper Expert 75354 300 mm Alligator Water Pump Pliers $66.43 |
|
|
Knipex 2621200 Cobra Water Pump Pliers 30 mm Capacity $55.66 |
|
|
C.K 3659A Water Pump Pliers 300mm $61.00 |
|
|
Kamasa 55991 Water Pump Plier $17.17 |
|
|
Draper 49156 250 mm VDE-Approved Water Pump Pliers $39.60 |
|
|
Draper Expert Knipex 88146 250 mm Cobra Water Pump Pliers $65.86 |
|
|
Draper Expert Knipex 44267 150 mm Cobra Water Pump Pliers $56.89 |
|
|
Knipex Cobra Water Pump Pliers 300 mm $75.29 |
|
|
Draper Expert Knipex 81189 300 mm Alligator Water Pump Pliers $69.51 |
|
|
Draper Expert Knipex 13758 180 mm Cobra Water Pump Pliers $59.74 |
|
|
Draper Expert Knipex 10954 250 mm Alligator Water Pump Pliers $49.17 |
|
|
Knipex 8801180 Alligator Water Pump Pliers $47.51 |
|
|
Knipex 8806250 VDE Alligator Water Pump Pliers $55.83 |
|
|
Draper Expert Knipex 32013 250 mm VDE Water Pump Pliers $60.23 |
|
|
Draper DIY Series 08670 240 mm Water Pump Pliers $10.37 |
|
|
Knipex 8801250L Alligator Water Pump Pliers Loose $45.29 |
|
|
Knipex 8701250 10-Inch Cobra Pliers $27.16 Features and Benefits:Box joint construction A new generation of water pump pliers, for easier and more secure workingPress button action for fast and firm adjustment directly on the work pieceSelected jaw opening is positively ensured. 11-position adjustmentSingle hand adjustmentSelf-gripping on pipes and nutsThe guard prevents operators fingers being pinchedThe unique jaw design shaped to elimin… |
|
|
Knipex 8603250 10-Inch Pliers Wrench $43.95 The pliers wrench is excellent for gripping, holding, pressing and bending work pieces. The high lever ratio, parallel jaws without profile and infinitely variable adjustment guarantee a secure and smooth gripping of the work piece free from backlash. . Zero backlash jaw surface pressure prevents damage to edges of sensitive components. Fast adjustment directly on the work piece by pushing a butto… |
|
|
Knipex 8801250E 10-Inch Alligator Pliers $20.75 Features and Benefits:Self-gripping on pipes and nutsUnique jaw design shaped to eliminate nut-burringSpecial hardened teeth (approx. 60 HRC)The guard prevents operators fingers being pinchedOptimum lever action7-position adjustmentMaterial: Chrome vanadium electric steel, oil-hardened 10″ – 1/8″ – 1 1/4″…. |
|
|
Pump Pliers – Replacement Parts For Deluxe Tool Kit – Model 62510-110 – Each (7 IN) Includes fourteen of the most essential tools for servicing laboratory equipment. Organized in heavy, blue vinyl, roll-up pouch with convenient see-through vinyl compartments. Two metal grommets provided for wall hanging. Tool handles cushioned in heavy rubber. Tools can also be purchased separately…. |
|
|
Klein D502-12 12-Inch Pump Pliers with 2-3/8-Inch Capacity $18.20 D502-10 Model Code: AC – Price is for 1 Each (part# D502-10) This item features: -Secure tongue and groove design for non-slip grip even with heavy pressure. -Wide range of versatile jaw positions. -Material: Alloy Steel. Len. = Overall Length Len. = Overall Length Model Code Model Description AAOverall Length:10 1/4 in, Jaw Opening:1 3/4 in [Max], Handle Color:Yellow/Black, Handle Type:Jour… |
|
|
0451-12D – Greenlee Pump Pliers 12in. $38.91 Pump Pliers 12in. dipped grip Double dipped grips for added comfort and slip resistance. Handles allow for easy storage of tools in pouches and tool bags. Precision-machined and through-hardened for consistent performance and longer life. Right-angled teeth for gripping in both directions. Riveting process ensures joint integrity. Exceeds ASME/ANSI specifications. Lifetime limited warranty. Note: … |
|
|
Stanley Tools 84-883 Max Grip 7 Pump Plier Stanley MaxGrip Self-Adjusting Groove Joint Plier Features – The self adjusting mechanism keeps jaw parallel to ensure maximum gripping power. – Laminated steel construction for strength. – Bi-material handles for comfort. The moulded handle does not slip off metal and will grab and grip rounded objects like pipes and tubes. – Jaw capacity. 51mm – Length. 7in… |
|
|
… |
|
|
KMC Missing Link (10-Speed Cd/6) $10.99 KMC Missing LinkNo tools neededItem SpecificationsColorSilverUnit of SaleCard of 6Width5.9mmNumber of Speeds10-Speed… |
|
|
Park Tool Head-Gear Lockring Wrench $16.95 Features two different radius hooks for a precise fit on most fixed-gear lockrings.Sized to fit rings with an outside diameter of 41, 42, 43, and 44mmAlso fits single speed cassette hubs using lockrings with external notches11-5/8″ (29cm) in length for excellent leverage… |
This entry was posted on Sunday, June 13th, 2010 at 6:10 pm and is filed under Uncategorized. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.
